CRYSTAL REPORTS JOB

I. What method do we use to remove the soot and charcoal to evaluate the damage?

- High pressure water blasting leaves behind water in electrical components, equipment and insulation, if not properly removed will cause unwanted corrosion and rot, increasing cleanup, damage and long term maintenance costs.

1. - Soda blasting leaves water and soda behind, which requires additional cleanup, increasing cleanup, damage and long term maintenance costs.
2. - Sand blasting leaves abrasive blast media behind, which if not cleaned up properly continues to cause damage in electrical components, gears and bearings. It continues to fall from horizontal surfaces, cracks and beams years after the job is done, increasing cleanup, damage and long term. maintenance costs.
3. - Dry ice blasting is the ultimate surface cleaning process, it leaves no secondary waste stream behind. The only cleanup after the dry ice blasting job is done is the removal of the debris caused by the fire.

II. How do we remove the soot, charcoal and smoke film from masonry and steel surfaces?

- Again this is an excellent application for dry ice blasting. Watch the movie clips on our web site to see how dry ice blasting cleans soot, smoke and charcoal from different types of surfaces.

III. Will we be able to remove that awful smoke smell?

- The removing of the smell is accomplished by removing the smell source and/or sealing the smell source to encapsulate it. Dry ice blasting removes the soot, charcoal and smoke film, which is the smell source, from accessible areas.